Gantry crane jig steps

(1), the sequence 4 engine liners two accordance with the "strut welding combination" to order a strut assembly and place it in a specific folder on  overhead gantry crane  by stop pin, baffles will order a strut positioning, by the screw clamp clamping sequence a pole; while the bolt will order 4 engine liners two positioning by Kuaiche screw clamping device to clamp.
(2), tack welding, release Kuaiche spiral clamping device, pull out the plug, remove the welding
(3), the weldment then be enclosed  bridge gantry crane  specific folder on the stop pin, baffles the weldment positioned by the clamping screw clamp weldments; horn after nut M6 and bearing assembly on weld by screw clamping mechanism on top of each cone on pins and screw on the platen clamping mechanism open to locate the spiral grooves on clamping
(4), the bearing nut M6 and speaker components and a three-pole welding surface, and release all the screw clamp,sino hoist M6 and the speaker holder clamping nut screw assembly plate by a spring clamp mechanism bounce its positioning on the cone along the pins out of weldments, and then launch the end plate from the stud screw clamping mechanism, the plate is rotated to the side of the weldment, then remove the weldment.